New Construction Regulations Section 148(1)d now requires all workers to be prevented from ejection while in an Aerial Work Platform (AWP).
In the past, typically the worker would be provided with a 6' lanyard to attach to the designated tie off point, usually somewhere near the floor of the AWP. The 6' lanyard would allow the worker a bit of movement in the lift. However if the worker was thrown out of the lift, a 6' lanyard is long enough to allow ejection from the AWP.
Therefore the construction industry must adopt a new method(s) of tying off while in a AWP's.
I think one easy quick solution to the issue is Self Retracting Lanyard's (SRL's).
SRL's come in a variety of sizes and configurations and are built to lock up when a sudden motion is detected such as falling. SRL's will almost always lock up within a maximum of 600 mm of lead out, and usually less. As a worker is about to go over the rails of an AWP, the unit will normally lock up before the worker is over the rails, that is provided the worker is not standing on the rails!
Always tie off to the designated tie off point within your AWP, if you cannot find it, consult the manual. FYI Operators manauls must be provided under the construction regulations. Some lifts designated for use inside industrial plants may not have tie off points. If you are on a construction site, let the rental company know, so they send you the right lift with proper anchor points.
Contractors must research new methods and write new procedures to match the new regulations.